Filter
Top Products
Rev. 0.00
5-9
STARLIneModeCommandSpecications
(3) Printer Status
Printer status is the status of the printer sent from the 3
rd
byte of the automatic status.
For the printer status, (the number of bytes added in Header -1 minus two) is returned.
Printer status is always updated for new information. (No log exists.)
The following shows the composition of the status.
<Printerstatus1Printerstatus(ThirdByte)>
Bit Contents Status By model
“0” “1”
HSP7000
7 Fixed at “0” - -
6 OFFLINE By Switch Input No Occurs ×
5 Cover Status Closed Open ○
4 Fixed at “0” - -
3 ONLINE/OFFLINE Status ONLINE OFFLINE ○
2 Compulsion SW Open Closed ○
1 ETB Command Not Executed Executed ○
0 Fixed at “0” - -
• ETB Command
Cleared when received at the host (by clearing bit 1 to 0, automatic status is not targeted to occur).
<Printerstatus2ErrorInformation(FourthByte)>
Bit Contents Status By model
“0” “1”
HSP7000
7 Fixed at “0” -
-
6
Stopped by high head
temperature
Not stopped Stopped
○
5 Non-recoverable Error No Yes
○
4 Fixed at “0” -
-
3 Auto-cutter Error No Yes
○
2 Mechanical Error No Yes
○
1 Not Used (Fixed at “0”)
-
0 Fixed at “0” -
-
<Printerstatus3ErrorInformation(FifthByte)>
Bit Contents Status By model
“0” “1”
HSP7000
7 Fixed at “0” - -
6
ReceptionBufferOverow Does not occur Occurs ○
5
Command Error (in Page
Mode)
No Yes
x
4 Fixed at “0” - -
3 BM Error No Yes ○
2 Presenter Paper Jam Error No Yes ×
1 Head Up Error No Yes ×
0 Fixed at “0” - -
• Reception Buffer Overflow
Cleared to 0 when returned to the host.
• Command Error (in Page Mode)
Command errors cleared to 0 when returned to the host.
• BM Error
On models that use a common PE and BM sensor, if a continuous error is detected beyond a determined amount, it
indicates not a black mark error, but a paper out error.