Filter
Top Products
Rev. 0.00
3-65
STARLineModeCommandSpecications
ESC GS EM DC1 m n1 n2
[Name] Set external buzzer drive pulse condition
[Code] ASCII ESC GS EM DC1 m n1 n2
Hexadecimal 1B 1D 19 11 m n1 n2
Decimal 27 29 25 17 m n1 n2
[DenedArea] Thermal : 1 ≤ m ≤ 2, 49 ≤ m ≤ 50, (“1” ≤ m ≤ “2”)
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
Slip :
1 ≤ m ≤ 2, 49 ≤ m ≤ 50, (“1” ≤ m ≤ “2”)
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
Validation :
1 ≤ m ≤ 2, 49 ≤ m ≤ 50, (“1” ≤ m ≤ “2”)
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
[Initial Value] Thermal : n1 = 0, n2 = 0
Slip : n1 = 0, n2 = 0
Validation : n1 = 0, n2 = 0
[Function] Set external buzzer drive pulse condition.
m specifies the buzzer drive terminal that sets the condition.
m Buzzer Drive Terminals
1, 49 Buzzer drive terminal 1
2, 50 Buzzer drive terminal 2
n1 specifies the energizing time; n2 specifies the delay time.
• Energizing time = 20 msec x n1
• Delay time = 20 msec x n2
The drive of the external buzzer set by this command is performed by ESC GS EM DC2 m n1 n2.
The set value is not initialized by ESC @, or CAN.
(Note) The settings using this command are valid for all stations and modes.
20 × n2 (msec) 20 × n1 (msec)
Printing and Paper Feed Prohibited
(Energizing Time)
(Delay Time)
OFF
ON
Drive Pulse
Print Operation