Filter
Top Products
Rev. 0.00
3-67
STARLineModeCommandSpecications
3-3-13) Print Settings
ESC RS d n
[Name] Set print density
[Code] ASCII ESC RS d n
Hexadecimal 1B 1E 64 n
Decimal 27 30 100 n
[DenedArea] Thermal : 0 ≤ n ≤ 15
48 ≤ n ≤ 57 (”0” ≤ n ≤ “9”), 65 ≤ n ≤ 70 (”A” ≤ n ≤ “F”)
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : -
Validation : -
[Function]
<Thermal>
Sets print density.
This command stops printing to be executed.
n Print Density
0, 48 Print density 1.3
1, 49 Print density 1.2
2, 50 Print density 1.1
3, 51 Print density 1.0
4, 52 Print density 0.9
5, 53 Print density 0.8
6, 54 Print density 0.7
7, 55 (Reserved)
8, 56 (Reserved)
9, 57 (Reserved)
10, 65 (Reserved)
11, 66 (Reserved)
12, 67 (Reserved)
13, 68 (Reserved)
14, 69 (Reserved)
15, 70 (Reserved)
<Slip>,<Validation>
Only setting is valid
Setting is valid after switching to thermal.