Filter
Top Products
Instruction Manual
100
Supported stop-bits values are ‘1’, ‘1.5’ and ‘2’.
Supported flow-control values are ‘Hardware’, ‘Software’ and ‘None’.
Supported Protocol Configuration
To ensure remote access to serial port 5 is configured as follows (denoted
by bolded text), you would need to issue the following commands (de-
noted with italicized text):
Telnet Access LAN: Disabled
#/bin/cong–-set=cong.ports.port5.ssh=on
SSH Access LAN: Enabled
#/bin/cong–-del=cong.ports.port5.telnet
Raw TCP via LAN: Disabled
#/bin/cong–-del=cong.ports.port5.tcp
The following command will synchronize the live system with the new
configuration.
#/bin/cong–-run=serialcong
Please Note: “/bin/config” commands can be combined into one com-
mand for convenience
Users
You can add a User to the system from the command line by following the
following instructions:
Determine the total number of existing Users (if you have no existing Us-
ers) you can assume this is 0.
#/bin/cong–-get=cong.users.total
This command should display:
cong.users.total1