Filter
Top Products
Chapter 5 Chassis Management Controller Service Procedures 5-3
For example, to deactivate CMC0 (10h):
Instead of deactivating a CMC, you can use the clia switchover command. The
clia switchover command transfers control of the Sun Datacenter Switch 3456
from one CMC to the other. For example:
Note – You can use the clia switchover command on either the active or the
inactive CMC with the same results. The inactive CMC becomes active, the active
CMC becomes inactive.
5.3 Removing CMCs
▼ Removing a CMC
1. If the active CMC is to be removed, use the clia switchover command to
transfer administration duties to the other CMC.
Otherwise, continue to Step 2.
2. Remove any cables connected to the CMC front panel.
3. Squeeze the latches on the release levers and wait for the blue
Ready-to-Remove LED to light.
4. Swing the release levers outward.
See
FIGURE 5-1.
# clia deactivate 10 0
Pigeon Point Shelf Manager Command Line Interpreter
Command issued via IPMB, status = 0 (0x0)
Command executed successfully
#
# clia switchover
#