Filter
Top Products
Recovery procedures
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
193
Recovery procedures
This section provides solutions for the following problems:
● Preserving data after a system failure on page 193
● Loss of power on page 194
● Probe command warnings on page 196
● Reseating HSI/P cards (R3V11 and V880 only) on page 197
● Resetting a device alias on page 198
● Remote console port problems on page 200
Preserving data after a system failure
Enter the sync command at the ok prompt to force any information on its way to the hard disk
to be written out immediately. This command is useful if the operating system fails or is
interrupted before preserving all data.
The sync command returns control to the operating system and performs the data-saving
operations. After the disk data is synchronized, the operating system begins to save a core
image of itself. If you do not need this core dump, you can interrupt the operation by pressing
Stop+A.