Filter
Top Products
Recovery procedures
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
201
7. Enter:
/usr/lib/saf/sac -t 300
This restarts SAC.
8. Enter:
sacadm -l
Confirm that SAC is running. The system should report the port status as ENABLED.
9. Enter:
/cms/install/bin/abcadm -i -b 9600 ttya
The following message should be displayed:
If this message is not displayed, escalate the problem using the normal channels.
Symptom: The system cannot dial out to report alarms using the Alarm Origination Manager
(AOM).
Solution: To correct this problem:
1. Enter:
tail /etc/uucp/Devices
The system should display the following:
2. Check the settings on the remote console modem. For the U.S. Robotics modem, make
sure that DIP switches 4 and 8 are down (ON). If these switches are not set correctly, you
may still be able to dial in, but it may not dial out.
3. Enter:
/opt/cc/install/aot.cssrXXxx.x/bin/setup
This restarts AOM. The release number XXxx.x depends on your installation.
To send a test alarm:
1. Enter the following commands to set up the test environment:
. /opt/cc/aot/bin/aom_env
cd /opt/cc/aot/bin
aom start
export PRODUCT_TYPE=TEST
ttya set to incoming port 9600 baud
ACU cua/b - Any Hayes
Direct cua/a - Any Direct
Direct cua/b - Any Direct