Filter
Top Products
Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0
145
10.2.5 How to Configure the System contact, Name
and Location
Command You can set the System contact, System Name and the System Location in the MIB
II RFC1213. Use the following CLI command to do so:
Parameters This command has the following parameters:
config
[sysContact = <quoted string>]
[sysName = <quoted string>]
[sysLocation = <quoted string>]
[traps <{disabled|enabled}>]
Parameter Value Description
sysContact <quoted string> System Contact
sysName <quoted string> System Name
sysLocation <quoted string> System Location
traps
enable or disable Enable or disable the sending
of traps.