Filter
Top Products
Chapter 4
SpeedTouch™ Configuration Management
E-DOC-CTC-20051017-0155 v1.0
36
Transfer the
configuration file to the
SpeedTouch™
To transfer a SpeedTouch™ configuration file stored on your local disk to the
SpeedTouch™, proceed as follows:
Step Action
1
Open an FTP session to the SpeedTouch™. At the user name prompt,
enter a user name and at the password prompt, the password (refer
to “The SpeedTouch™ Multi Level Access Policy Configuration
Guide” for more information).
2 If required, save the current SpeedTouch™ configuration via the
quote site saveall command:
ftp> quote site saveall
200-
200 CLI command "saveall" executed
3 Enter binary file transfer mode. Optionally you can enable hashing:
ftp> bin
200 TYPE is now 8-bit binary
ftp> hash
Hash mark printing On ftp: (2048 bytes/hash mark).
4 Go to the SpeedTouch™ ‘/dl’ subdirectory:
ftp> cd dl
5 You can check whether a user.ini configuration file, or other
configuration files are stored in the ‘/dl’ subdirectory by making a
listing of the subdirectory’s contents:
ftp> dir
200 Connected to 192.168.1.254
150 Opening data connection for /bin/ls
-rwxrwxrwx 1 0 0 20 Jun 29 1971 start.cmd
-rwxrwxrwx 1 0 0 2952448 Jun 29 1971 ZZUIAA5.314
-r--r--r-- 1 0 0 9 Jun 29 1971 seed.dat
-r--r--r-- 1 0 0 729 Jun 29 1971 sslcert.pem
-r--r--r-- 1 0 0 908 Jun 29 1971 sslkey.pem
-r--r--r-- 1 0 0 692 Jun 29 1971 sshdsa.pem
-rwxrwxrwx 1 0 0 66920 Jun 29 1971 user.ini
-rw-rw-rw- 1 0 0 4056 Jun 29 1971 user.tpl
-rw-rw-r-- 1 0 0 34633 Jun 29 1971 security.cfg
226 Options: -l : 9 matches total
ftp: 600 bytes received in 0,00Seconds 600000,00Kbytes/
sec.ftp: 400 bytes received in 0.01Seconds 40.00Kbytes/sec.
6 In case the configuration file you intend to upload has the same
name as (one of) the configuration file(s) on the SpeedTouch™ file
system (for example user.ini), you must either:
Rename the file name, of the configuration file stored on your
local disk
Delete the file from the SpeedTouch™ file system.
7 Optionally you can clean up the SpeedTouch™’s file system via the
:software cleanup CLI command:
ftp> quote site software cleanup
200-
200 CLI command "software cleanup" executed