Filter
Top Products
Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0
168
Syslog host on a
remote network
The default SYSLOG SpeedTouch™ service is configured to allow traffic from the
SpeedTouch™ syslog daemon towards the WAN:
Therefore, no additional configuration is needed in case you want to configure a
syslog host on a remote network.
The example below shows the syslog rule to add for a syslog host with IP address
192.6.11.1. The local syslog host (192.168.1.10), configured before (See “Syslog
host on the local network”) will receive all generated syslog messages; the remote
syslog host only receives syslog messages from all facilities with severity warning,
error, critical, alert or emergency (all facilities, with severity warning and higher):
=>:service system list name=SYSLOG expand=enabled
Idx Name Protocol SrcPort DstPort Group Sta
te
-----------------------------------------------------------------------
1 SYSLOG udp 514 ena
bled
Description................ System Logging Events
Properties................. client
Managed parameters......... state srcip
Source Ip Selection........ auto
Interface Access List...... any
Ip Access List............. any
=>
=>:syslog ruleadd fac=all sev=debug dest=192.6.11.1
=>:syslog list
1: all.debug 192.6.11.1
2: all.debug 192.168.1.10
=>