Filter
Top Products
Chapter 11
SpeedTouch™ Advanced Diagnostics
E-DOC-CTC-20051017-0155 v1.0
183
ATM Auto-Configuration
via TR-37/ ILMI 4.0
The ILMI operates between the network and the ATM Network Termination at the
customer premises for example the SpeedTouch™. ILMI 4.0 is supported on VP/VC
0/16. Meaning that the VCC or VPC can be provisioned via this management
channel. The information received via the management channel can be used to
dynamically add terminated connections.
The QOS information received via the management channel will create dynamic
“qosbook” entries. This information shall be available on the CLI. This information
shall not be saved.
The VP/VC information received via the management channel will dynamically add,
for example an enabled LLC/SNAP Bridged interface or an attached PPPoE relay
interface (depending on the received TR-37 information) on the SpeedTouch.
A CLI command is available to set the Auto-configuration mode between ACTIVE,
PASSIVE, and PSEUDO.
Use the following command to display the information retrieved via ILMI.
=>:autopvc config mode=active
=>
The third option “PSEUDO” is used for the SpeedTouch with ATMFORUM
that is using the VP= 0.
=>:autopvc list
Address Type Class BestEff Par1 Par2 Par3 Par4 Par5
8.36 CBR.c0/UBR.1 ubr Enabled Tx: 120 24 2048 12 12
CBR.c0/UBR.1 Rx: 120 24 24 0 0
=>