Filter
Top Products
Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0
151
10.2.9 How to Allow Remote SNMP
About Remote SNMP It is possible to allow to allow a remote SNMP manager to monitor the
SpeedTouch™. To do this, add the WAN interface to the service access list.
Command Use the following command:
Receiving Traps To allow the remote SNMP manager to receive SNMP traps generated by the
SpeedTouch™, no extra configuration is necessary. It is, however, possible to
configure which traps are sent to a manager. For more information, refer to
“10.2.12 How to Configure the Traps” on page 158.
You can also configure authentication for remote access to SNMP. For more
information, refer to “10.2.11 How to Restrict SNMP Access” on page 157.
=>service system ifadd name SNMPV3_AGENT group wan