Filter
Top Products
Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0
167
10.3.4 Remote Syslog Notification
Introduction The SpeedTouch™ can be configured to send all or a selection of generated syslog
messages to a host on the local or a remote network IP address.
This section describes how to configure the SpeedTouch™ syslog daemon to send
messages to a particular host.
Preconditions The host to send the syslog messages to, should have syslog daemon software
installed for capturing the messages, and a known, fixed IP address.
Syslog host on
the local network
By default, no traffic restrictions apply for the local network. Simply add a syslog
rule via the SpeedTouch™ syslog configuration web page or the CLI. Specify the IP
address of the host, and optionally refine the set of syslog messages to send.
The following example shows the configuration via the CLI for a syslog host on the
local network with fixed IP address 192.168.1.10 to send all generated syslog mes-
sages (all facilities, with severity debug and higher) to:
You can specify one or a selection of (comma-separated) or all facilities.
Specifying a severity actually means to send syslog messages with a
severity as specified, and all messages with a higher severity.
For a priority listing see “ Syslog priority severities”.
=>:syslog ruleadd fac=all sev=debug dest=192.168.1.10
=>saveall
=>