Filter
Top Products
Chapter 3
SpeedTouch™ System Software
E-DOC-CTC-20051017-0155 v1.0
22
Mark system software
file as Passive Software
Version
You must identify the system software you transferred to the SpeedTouch™ ‘/dl’
subdirectory as passive software version to allow the SpeedTouch™ to mark the file
as system software.
Proceeding from the same FTP session you opened to transfer the file, use the
quote site software setpassive file=<file name> command, where
<file name> represents the name of the system software file you transferred via the
previous procedure:
Activate the upgrade/
restored system
software
To activate the upgrade or restored system software, the same mechanism as used
via the Web Interface is valid: the system software files are switched.
Proceeding from the same FTP session you opened in the previous procedures, use
the
quote site software switch command to restart the SpeedTouch™ and
activate the newly uploaded upgrade system software:
During restart, the SpeedTouch™ will switch the passive and active system
software files and mark the newly uploaded system software as active software
version.
Due to the restart of the SpeedTouch™ any open FTP or Telnet session will be
closed.
ftp> quote site software setpassive file=ZZUIAA5.411
200- Flash image : 5.4.0.10.0
200- Active SW : ZZUIAA5.40A (5.4.0.a.0)
200- Passive SW : ZZUIAA5.411 (5.4.0.a.0)
200-
200 CLI command "software version" executed
ftp>
ftp> quote site software switch
200-
Connection closed by remote host.
ftp>