Filter
Top Products
e-STUDIO281c/351c/451c
Cautions after the completion of the adjustment
Too small a set value may possibly cause the image to become light, if a darker image is laid out at the trailing
edge of the original. Therefore, carefully perform the adjustment, while checking the copy image.
Remarks
• Enter the value mentioned in the procedures or one within the recommended value range for the adjustment.
Otherwise, it may cause a loss in copier performance, including degradation in the image quality and reduction
in the life of the consumables.
• The desired image quality may not be obtained, depending on the type of paper used. In this case, use the
recommended paper and then print or adjust the image quality.
• If printing on another type of paper causes a problem with the image quality after the adjustment, return the set
values (for codes 05-239 and 1822) to the defaults and then perform the adjustment again.
• The adjustment will make up for the gap in the image quality and density at the trailing edge between the front
and back of the paper in duplex copying. Particularly, if the image at the trailing edge on the back of the paper
is light, the image quality may be improved by decreasing the set value for the transfer roller bias output.
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
1.2