Filter
Top Products
Machine Configuration August, 2006
Spec-28
No. Component Function
of the drum in the cyan PCU.
S66 Potential Sensor - Y
Reads the potential sensor pattern from the surface
of the drum in the yellow PCU.
S67
Temperature Sensor -
Optics 1
1 of 2 sensors (located near the left f-theta lens)
that monitors the temperature in the optics unit. The
results are used in the MUSIC process.
S68
Temperature Sensor -
Optics 2
1 of 2 sensors (located near the right f-theta lens)
that monitors the temperature in the optics unit.
The results are used in the MUSIC process.
S69 Toner End Sensor - M Detects toner end for magenta toner.
S70 Toner End Sensor - K Detects toner end for black toner.
S71 Toner End Sensor - Y Detects toner end for yellow toner.
S72 Toner End Sensor - C Detects toner end for cyan toner.
S73 Scanner HP Sensor Detects the home position of the scanner.
S74 Original Width Sensors
APS1 (a board) holds two original width sensors
under the exposure glass. The detection
combinations of these sensors determine the width
of the original on the exposure glass positioned for
LEF.
S75 Original Length Sensors - 1
APS2 (a board) holds two original length sensors
under the exposure glass. The detection
combinations of these sensors determine the
length of the original on the exposure glass
positioned for SEF.
S76 Original Length Sensor -2
APS3 (a board) holds one original length sensor
under the exposure glass. The detection
combination of this sensor and other sensors
determine the length of the original on the exposure
glass positioned for SEF.
S77 Accordion Jam Sensor
Detects jams at the fusing exit by confirming that
paper arrives at the prescribed time.
S78 Fusing Exit Sensor
Detects jams at the fusing exit by confirming that
paper leaves at the prescribed time.
S79 LCT Relay Sensor Confirms whether the LCT is set correctly.
No. Component Function
LEDs
LED1 Double-Feed Detection LED
Emits light which is reflected from the paper to the
double feed sensor to test the translucence of
each sheet for double-feed detection.
LED2 Accordion Jam Sensor (LED)
Flashes to show the user which lever to release to
remove a paper jam from the fusing rollers.
LED3 Fusing Exit Sensor (LED)
Flashes to show the user which lever to release to
remove a paper jam from the fusing unit.