Filter
Top Products
August, 2006 USING THE DEBUG LOG
5-209
4. Next, select the target destination where the debug information will be saved.
Under “5857 Save Debug Log”, press “2 Target”, enter “2” with the operation
panel key to select the hard disk as the target destination, then press .
COPY : SP-5-857-002
Save Debug Log
Target (2:HDD 3:SD Card)
_2_
Initial 2
NOTE: Select “3 SD Card” to save the debug information directly to the SD
card if it is inserted in the service slot.
5. Now press “5858” and specify the events that you want to record in the debug
log. SP5858 (Debug Save When) provides the following items for selection.
1 Engine SC Error
Saves data when an engine-related
SC code is generated.
2 Controller SC Error
Saves debug data when a controller-
related SC Code is generated.
3 Any SC Error
Saves data only for the SC code that
you specify by entering code number.
4 Jam Saves data for jams.
NOTE: More than one event can be selected.
Example 1: To Select Items 1, 2, 4
Press the appropriate items(s). Press “ON” for each selection. This example
shows “Engine SC Error” selected.
COPY : SP-5-858-001
Debug Save When
Engine SC Error
__OFF__ __ON__
Example 2: To Specify an SC Code
Press “3 Any SC Error”, enter the 3-digit SC code number with the operation
panel number keys, then press . This example shows an entry for SC670.
COPY : SP-5-858-001
Debug Save When
Any SC Error
__670
NOTE: For details about SC code numbers, please refer to the SC tables in
Section “4. Troubleshooting”.