Filter
Top Products
SERVICE PROGRAM TABLES August, 2006
5-138
6115
Max Prestack Number of Pre-Stack Sheets
This SP sets the number of sheets sent to the pre-stack tray. With this SP set to the
default (3):
• 3 sheets are sent to the pre-stack tray.
• When the 4th sheet feeds, the 4th sheet and 3 sheets from the pre-stack tray are
sent to the stapling tray together
Note: You may need to adjust this setting or switch it off when feeding thick or slick
paper.
0:None-3:3Shts [0~3/1 sheet]
0: None
1: 1 sheet
2: 2 sheets
3: 3 sheets
6116
Thk Sht Count Thick Sheet Count
This SP sets the number of sheets of normal thickness to count for one thick sheet.
The default (3) counts three sheets of normal thickness for one thick sheet.
[1~3/1]
6117
Allow Tnk Punch Allow Punching of OHP Sheets
This SP allows you to switch on punching of OHP sheets. Normally, OHP sheets
cannot be punched. If this SP is switched on (1), the performance of the finisher
cannot be guaranteed (the sheets may jam).
[0~1/1]
6118
Output Jog On Output Jogger Operation Off/On
This SP switches the jogging operation of the output jogger attached to the side of the
finisher off and on.
[0~1/1] 0: Off, 1: On
Note: After installation of the Output Jogger Unit Type 3260 (B703), this SP must be
set to "1" for the jogging motor to operate the jogging fences.
6119
No Z-Fold/Punch Prohibit Z-Folding and Punching Japan Only
Switch Z-folding off and on. Default: 0 (Off)
0:No 1:Yes
6120
Free Run Free Run 1: Post Processing
These SPs set the peripherals list below in the free run mode for testing.
001 Free Run 1 System Free Run Finishers B701/B700, B706
002 Free Run 1 Free Run (Endurance Testing)
Finisher B706
003 Free Run 3 Free Run (Not Used)
004 Free Run 4 Shift, Free Run Finisher B706