Filter
Top Products
User’s Manual 6-12
Power and Power-Up Modes
Starting the computer by password
If you have already registered a password, there is one way to start the
computer:
■ Enter the password manually.
To enter a password manually, follow the steps as detailed below:
1. Turn on the power as described in Chapter 1, Getting Started. The
following message will appear in the screen:
S Password=
2. Enter the Password.
3. Press ENTER.
Power-up modes
The computer has three different power-up modes as follows:
■ Shut Down Mode : The computer will shut down without saving data - in
view of this you must always save your work before you turn the
computer off.
■ Hibernation Mode : Data in memory will be saved to the hard disk drive.
■ Sleep Mode : Data will be maintained in the computer's memory.
Windows utilities
You can configure various settings associated with both Sleep Mode and
Hibernation Mode within the Power Options (to access it, Start -> Control
Panel -> System and Security -> Power Options).
Hot keys
You can use the FN + F3 hot key to enter Sleep Mode or FN + F4 to enter
Hibernation Mode - please refer to Chapter 5, The Keyboard for further
details.
The password is necessary only if the computer was turned off in Shut
Down Mode or Hibernation Mode.
It is not needed in Sleep Mode and Restart.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Please refer to the sections Turning on the power and Turning off the
power in Chapter 1, Getting Started for further information.