Filter
Top Products
3 FAXING FROM CLIENT COMPUTERS
48 Faxing from Applications
1) To
This displays the specified recipients list.
2) [Select From Address Book]
Click to launch the AddressBook Viewer. You can select recipients from the address book.
P.37 “Specifying recipients from address book”
3) [New]
Click to add new recipient by entering manually. The Direct Dial dialog box appears.
P.41 “Entering a recipient manually”
4) [Remove]
Select a recipient in the “To” list and click this to remove the recipient from the list.
5) Resolution
Select the resolution for the fax.
- Standard (200 x 100 dpi) — Select this to send a document in Standard mode (200 x
100 dpi).
- Fine (200 x 200 dpi) — Select this to send a document in Fine mode (200 x 200 dpi).
- Super Fine (200 x 400 dpi) — Select this to send a document in Super Fine mode (200
x 400 dpi).
- Ultra Fine (400 x 400 dpi) — Select this to send a document in Ultra Fine mode (400 x
400 dpi).
6) Dept. Code
Enter 5-digit department code if required. When the department code is enabled on this
equipment, you must enter the department code to send a fax.
If network fax transmission is performed with an incorrect department code, a dialog box
indicating that it is incorrect appears. In this case, enter the correct one or stop transmitting.
If this dialog box does not appear, the job becomes invalid and is deleted. An error report is
then printed out from this equipment.
1
5
7
2
3
4
6
8