Filter
Top Products
Replacement Procedures
Satellite L20 Maintenance Manual(960-Q01) 171
4.9 Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-13
and 4-14).
1. Turn over the computer and remove the following screws securing an optical disk
drive.
• M2.5×6.0B FLAT BIND screw x1
2. Upside down the computer.
3. Remove the following screw securing the ODD driver.
M2.5×6.0B Flat BIND screw x1
3. Disconnect an optical disk drive toward the arrow direction from the connector
CN25 on the system board.