Filter
Top Products
Replacement Procedures
Satellite L20 Maintenance Manual(960-Q01) 185
Installing the cover assembly
The following describes the procedure for installing the cover assembly (See Figure 4-21 to
4-24).
1. Install the cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.5×2.0B FLAT BIND screw x3
• M2.5×6.0B FLAT BIND screw x18
• M2.5×3.0B FLAT BIND screw x2