Filter
Top Products
Replacement Procedures
ODD bracke
t
M2.0
×
3.0
Figure 4-11 Disassembling the ODD bracket
Installing an optical disk drive
The following describes the procedure for installing an optical disk drive (See Figure 4-13
and 4-14).
1. Attach the ODD bracket to an optical disk drive and secure it with the following
screws.
• M2.0×3.0 Flat BIND screw x3
2. Insert an optical disk drive assembly into the slot and connect it to the connector
CN25 on the system board.
3. Secure the ODD drive with the following screw.
M2.5X6.0 Flat BIND screw X1
4. Turn over the computer and secure an optical disk drive with the following screws.
Satellite L20 Maintenance Manual(960-Q01) 173