Filter
Top Products
Replacement Procedures
4.12 Touch pad
Removing the touch pad
The following describes the procedure for removing the touch pad (See Figure 4-31).
1. Peel off the glass tape and disconnect the touch pad flat cable from the connector on
the touch pad and peel the al foil .
2. Remove the following screws securing the touch pad plate.
• M2.5×3.0B SUPER THIN HEAD screw x5
3. Turning up the insulator, remove the touch pad plate.
4. Peel off and remove the touch pad from the cover assembly.
Touch pad
M2.5x3.0B
SUPER THIN HEAD
M2.5x3.0B SUPER THIN HEAD
Touch pad flat cable
Al foil
M2.5x3.0B
SUPER THIN HEAD
Touch pad plate
Al foil
Figure 4-20 Removing the touch pad
186 Satellite L20 Maintenance Manual(960-Q01)