Filter
Top Products
5. READ (X) AND RESET (Z) REPORTS
EO1-11110
5-4
5.1 Combination Reports
5.1 Combination Reports
Multiple reports can be programmed to be issued in one operation sequence. The following are reports
programmable for combinations (max. 5 reports in one table, max. 3 tables). Ask your TOSHIBA TEC
representative for information of the contents of your Combination Report Tables or for changes.
REPORT NAME AVAILABLE REPORTS
Financial Report X Z GTX GTZ
All Cashier Report X Z GTX GTZ
All Salesperson Report X Z
Credit Company Sales Report X Z GTX GTZ
Department Group Report X GTX
Media Sales and In-drawer Report X
Hourly Range Report X Z
All Department Report X Z GTX GTZ
All Media Sales & Cash-in-drawer Report X
All PLU Report X Z GTX GTZ
All Customer Files Report X
PLU Group Sales Report X Z GTX GTZ
KEY OPERATION: Mode Lock: X for Read
Z for Reset
Enter the Report Combination-ID No.:
None (simply depress [AT/TL]): Daily Combination Report Table No.1
200: GT Combination Report Table No.1
1: Daily Combination Report Table No.2
201: GT Combination Report Table No.2
2: Daily Combination Report Table No.3
202: GT Combination Report Table No.3
NOTES: 1. When the mode set for taking combination reports does not match the mode of a report
contained in the table, that report will be skipped.
2. If no combination reports data have been programmed, Combination Report Table No. 1 (which
is issued by depressing the [AT/TL] key alone for Daily Reports and depressing 200 [AT/TL] for
GT Reports) is auto-preset with All Department Report and Financial Report. It will be active as
Table No. 1 content unless no data are programmed for Table No. 1.
3. The report output order is determined by the order programmed in each table.
4. The drawer will open when a contained report is ruled to open the drawer.
5.2 GENERAL NOTES ON REPORT TAKINGS
1. The cashier signed-OFF or signed-OUT condition is required for taking any Z reports in the Code Entry
Method. (Otherwise, an error will result when the Mode Lock is turned to the “X” or “Z” position.) However, in
case of a standalone system with PC connected and CVS spec. selected, X/Z reports can be taken during
sign-ON and sales entries.
2. Reset reports will be printed on the receipt roll as well as on journal, and issued, regardless of the current
Receipt-ON/OFF status.
3. The [ITEM CORR] (or [VOID]) key may be depressed halfway during printing a report, for the purpose to
abort the receipt issuance (except for some short reports). When a report-abort has been operated for a reset
report, the memory of the report data will not be cleared.
| | [AT/TL]