2. OPERATIONS BEFORE IN-LINE SERVICE
EO1-11110
2-2
2.2 TERMINAL DESIGNATION
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
19-12-1994 MON #1
P00
03 #3003
0023 14:33TM
2.2 TERMINAL DESIGNATION
This operation can be performed before any in-line service operation. When this operation is skipped, no specific
terminals are designated, i.e., the in-line service operations will be performed to all the terminals.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET, X, or Z (depending on the in-line service operations to follow)
RTR Declaration ON Status (i.e., the IN-LINE Lamp should be illuminated)
To be operated on the Master Terminal only.
[#] |Register No.| [#] [AT/TL]
. . .
Enter the Register No. of the
Terminal subject to the in-line
service operations to follow.
Repeat for other terminals if more are
subject to the in-line service operation.
NOTE: The Terminal Designation once declared by the above operation will be canceled by changing the
position of the Mode Lock, or by RTR Declaration Cancel, or by turning OFF and ON the power of the
terminal. The designation is automatically canceled on completion of the operation to follow or when a
new designation is operated.
ex.) To designate the following Terminal out of two terminals in the system:
Terminal ID No.3: Register No. 3003
Mode Lock: SET (if operated before DLLs)
The RTR Declaration must be ON (i.e., the IN-LINE Lamp must be illuminated; if not, depress the [RTR]
key to declare RTR status).
[#] 3003 [#] [AT/TL]
(Issues a receipt, printing the Register Nos. of the terminals designated in the above operation.)