Filter
Top Products
3. RESERVATION
EO1-11110
3-3
TABLE OF RESERVATION OPERATIONS
(continued)
RTR Declaration: ON
3.2 REPORT RESERVATION PRINT FORMAT
Report Name Mode Key Operation
Lock
CUSTOMER FILE REPORTS
(for Check Track Memory type only)
• All Files Read X 615 [AT/TL]
• All Files Reset (Version 1.7 or after) Z 615 [AT/TL]
• Zone Files Read X 615 [#] → |Zone-start File Code|
[@/FOR] → |Zone-end File Code| [AT/TL]
• Zone Files Reset Z 615 [#] → |Zone-start File Code|
(Version 1.7 or after) [@/FOR] → |Zone-end File Code| [AT/TL]
NOTES: 1. Reservation function is unavailable when the Satellite Terminals perform the transactions in SET,
X and Z modes.
2. Reservation function is only an operation to copy report data into the communication buffer.
Therefore, actual report cannot be issued by this function. To issue a report, key operation to
issue it is further necessary on the Master Terminal. Refer to the next chapter “4. READ AND
RESET REPORTS” regarding key operation to issue a report.
3. When Resevation operation is performed before the data is set in the communication buffer, “DT
R” will be printed.
When the reservation reset is performed under the condition that the reset data is in the
communication buffer, “DT Z” will be printed.
3.2. REPORT RESERVATION PRINT FORMAT
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
12-19-1994 MON #1
************************
RESERVE
************************
#111101 ∆ ∆ ∆ ∆
#222202 ∆ ∆ ∆ ∆
#999909 ∆ ∆ ∆ ∆
0160 20:00TM
.....
RTR Symbol
Reservation Symbol
RTR Symbol
Register No. and Status
?: No response
BUSY: The terminal is busy
Blank: Other statuses
DT
R: Already reserved
DT
Z: Reset data exists
Report Name