Filter
Top Products
6. PROGRAMMING OPERATIONS
EO1-11110
6-30
6.15 LINK-PLU TABLE PROGRAMMING (Submode 25)
This submode programs Link-PLU Tables and their respective Sub-link PLUs. When a PLU is programmed with a
Link-PLU Table No. (Address 10 of the PLU TABLE PROGRAMMING operation), an entry of the PLU will
automatically enter the Sub-link PLU that is programmed in the Link-PLU Table No. Refer to the “Link-PLU Table
No.” description in the PLU TABLE PROGRAMMING, Submode 4, as to details of PLU-to-PLU linkage.
Programming
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
Barcode Scanning
25 [@/FOR] |Link-PLU Table No.| [ST] |Sub-link PLU Code| [PLU] [AT/TL]
Max. 6 or 13 digits (Enter the
code of the PLU to be auto-
entered when the Head-link
PLU is entered in a sale.)
*
Repeat for other tables.
1 to 99 (Enter the No.
programmed in the
Head-link PLU item in
Submode 4.)
* (For sequentially
programming
tables, the Table
No. specification
can be skipped.)
6.15 LINK-PLU TABLE PROGRAMMING (Submode 25)
Repeat for other salespersons to be deleted.
Deletion
CONDITION After Daily Salesperson Reset
OPERATION Mode Lock: SET
20 [@/FOR] [ITEM CORR] |Salesperson Code| [ST] [AT/TL]
or
[VOID]
NOTE: When a Salesperson Code is deleted in the above operation, no entries using that code will be
accepted until the code is again opened in the “Programming” operation already described.
ex.) To delete Salesperson Code 3 (name: Jansen) that was once programmed:
Mode Lock: SET, 20 [@/FOR].
[ITEM CORR] 3 [ST]
[AT/TL]
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
12-19-1994 MON #3001
P20
03 Jansen
------------------------
0048