Filter
Top Products
4.14 Bluetooth Module 4 Replacement Procedures
4.15 RGB Board
Removing the RGB Board
Remove the RGB board according to the following procedures and Figure 4.27:
1. Disconnect the RGB board cable and remove one M2x3 screw securing the RGB board to the
logic lower assembly, as shown in Figure 4.27.
2. Lift the RGB board at an angle and then remove it from the logic lower assembly. Take care
to disengage the connectors from their respective ports without damaging them.
M2x3
Figure 4.27 Removing the RGB board
Installing the RGB Board
Install the RGB board according to the following procedure:
1. Insert the RGB board into the logic lower assembly at an angle and then press it down to seat
it on the logic lower assembly.
2. Connect the RGB board FFC to the motherboard.
Satellite T210/T215/Pro T210/Pro T215 Maintenance Manual 4-35