Filter
Top Products
Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 245
Wireless Distribution System
This table shows a quick view of WDS commands and links to detailed examples.
Configuring a WDS Link
To set up a Wireless Distribution System (WDS) link between two wireless networks:
1. Enable the WDS interface (
wlan0wds0
) on the current access point:
USR5453-AP#
set interface wlan0wds0 status up
USR5453-AP#
set interface wlan0wds0 radio wlan0
2. Provide the MAC address of the remote access point to which you want to link:
USR5453-AP#
set interface wlan0wds0 remote-mac
MAC_Address_Of_Remote_AP
For example:
USR5453-AP#
set interface wlan0wds0 remote-mac 00:E0:B8:76:1B:14
Getting Details on a WDS Configuration
Verify the configuration of the WDS link you just configured by getting details on the WDS interface:
USR5453-AP#
get interface wlan0wds0 detail
Field Value
-------------------------------------------------------
type wds
status up
description Wireless Distribution System - Link 1
mac 00:E0:B8:76:26:08
ip
mask
static-ip
static-mask
rx-bytes 0
rx-packets 0
rx-errors 0
rx-drop 0
rx-fifo 0
Note
Before configuring this feature, make sure you are familiar with the names of the interfaces as
described in “Understanding Interfaces as Presented in the CLI” on page 190
. The interface name you
reference in a command determines whether a setting applies to a wired or wireless interface or to the
Internal or Guest network.
WDS Command Example
Configuring a WDS Link See detailed command example below.
Configuring a WDS Link
get interface wlan0wds0 detail