4ViewSonic PJL6243
4
NOTEFORCUSTOMERSINTHEUS
Hg
LAMP(S) INSIDE THIS PRODUCT CONTAIN
MERCURY AND MUST BE RECYCLED OR
DISPOSED OF ACCORDING TO LOCAL,
STATE OR FEDERAL LAWS.
TotheOwner
CAUTION:
TOREDUCETHERISKOFELECTRICSHOCK,
DONOTREMOVECOVER(ORBACK).NO
USER-SERVICEABLEPARTSINSIDEEXCEPT
LAMPREPLACEMENT.REFERSERVICINGTO
QUALIFIED SERVICE PERSONNEL.
THISSYMBOLINDICATESTHAT
DANGEROUSVOLTAGECONSTITUTINGA
RISKOFELECTRICSHOCKISPRESENT
WITHINTHISUNIT.
THISSYMBOLINDICATESTHATTHERE
AREIMPORTANTOPERATINGAND
MAINTENANCEINSTRUCTIONSINTHE
USERGUIDEWITHTHISUNIT.
CAUTION
RISKOFELECTRICSHOCK
DONOTOPEN
Before installing and operating this projector, read this
manual thoroughly.
This projector provides many convenient features and
functions.
Operating the projector properly enables you to manage
those features and maintains it in good condition
for many years to come. Improper operation may
result in not only shortening the product-life, but also
malfunctions, fire hazard, or other accidents.
If your projector seems to operate improperly, read this
manual again, check operations and cable connections
and try the solutions in the “Troubleshooting” section on
pages 63-65 of this manual. If the problem still persists,
contact the dealer where you purchased the projector or
the service center.
Safety Precaution
CAUTION
DONOTSETTHEPROJECTORINGREASY,WET,
ORSMOKYCONDITIONSSUCHASINAKITCHEN
TOPREVENTABREAKDOWNORADISASTER.IF
THEPROJECTORCOMESINCONTACTWITHOILOR
CHEMICALS,ITMAYBECOMEDETERIORATED.
READANDKEEPTHISUSERGUIDEFORLATERUSE.
WARNING:
THISAPPARATUSMUSTBEEARTHED.
TOREDUCETHERISKOFFIREOR
ELECTRICSHOCK,DONOTEXPOSE
THISAPPLIANCETORAINORMOISTURE.
– This projector produces intense light from the projection
lens. Do not stare directly into the lens, otherwise eye
damage could result. Be especially careful that children
do not stare directly into the beam.
– Install the projector in a proper position. Improper
positioning may reduce the lamp life and result in
severe accident or fire hazard.
– Allowing the proper amount of space on the top, sides,
and rear of the projector cabinet is critical for proper
air circulation and cooling of the unit. The dimension
shown here indicate the minimum space required.
If the projector is to be built into a compartment or
similarly enclosed, these minimum distances must be
maintained.
– Do not cover the ventilation slot on the projector. Heat
build-up can reduce the service life of your projector,
and can also be dangerous.
– If the projector is unused for an extended time, unplug
the projector from the power outlet.
– Do not project the same image for a long time. The
afterimage may remain on the LCD panels by the
characteristic of panel.
SIDE and TOP REAR
0.7’(20cm)
1.5’(50cm) 3’(1m) 3’(1m)
20cm
50cm 1m 1m
CAUTION
NOTFORUSEINACOMPUTERROOMASDEFINED
INTHESTANDARDFORTHEPROTECTIONOF
ELECTRONICCOMPUTER/DATAPROCESSING
EQUIPMENT,ANSI/NFPA75.