ViewSonic PJL6243 Projector User Manual


  Open as PDF
of 177
 
65ViewSonic PJL6243
65
 Theimageisdistortedorrunsoff. – Check PC adjust menu or Screen menu and adjust them.
See pages 30-31, 34-35.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up. you have set). See pages 19, 53-54.
 TheRemoteControldoes – Check the batteries.
not work. – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 52.
– Unlock the Key lock function for the remote control function.
See page 53.
Indicator blinks or lights. – Check the status of the projector with referring to "Indicators and
projector Condition". See page 68.
Theexclamationmarkappears – Your operation is invalid. Operate correctly.
on the screen.
 Topcontroldoesnotwork.– The top control is not available if the top control is locked at Keylock
under Security of Setting section. See page 53.
Unable to unlock the Logo PIN – Contact the dealer where you purchased the projector or the service
codelock,Securitykeylock center.
or Security PIN code lock.
– The projector detects an abnormal condition. Unplug the AC power cord
and contact the dealer where you purchased the projector or the service
center.
appears on the screen
Appendix
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased
the projector or the service center. Specify the model number and explain about the problem. We will
advise you how to obtain service.
 previous next