Filter
Top Products
12ViewSonic PJL6243
12
Adjustable Foot
Adjustable FootFoot Lock Latch
Projection angle can be adjusted up to 10.0
degrees with the adjustable foot.
Lift the front of the projector and push the foot
lock latch on the projector.
Release the foot lock latch to lock the adjustable
foot and rotate the adjustable foot to adjust the
position and tilt.
To retract the adjustable foot, lift the front of the projector
and push and undo the foot lock latch. Keystone
distortion of the projected image can be corrected
by menu operation. (see pages 23, 35, 43, 45)
Part Names and Functions
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
TwoAAAsizebatteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in compartment.
1
2
3
Point the remote control toward the projector
(Infrared Remote Receiver) when pressing the
buttons. Maximum operating range for the remote
control is about 16.4'(5 m) and 60 degrees in front
of the projector.
Remote Control Operating Range
Remote Control Battery Installation
16.4'
(5 m)
30°
Remote control
30°
The 2 different remote control codes (Code 1–Code
2) are assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment
next to each other are operated at the same time.
Change the remote control code for the projector
first before changing that for the remote control. See
"Remote control" in the Setting Menu on page 52.
Press and hold the MENU and IMAGE buttons for
more than five seconds to switch between the Code
1 and Code 2. The initial code is set to Code 1.
Remote Control Code
MENU button
IMAGE button