Filter
Top Products
INSTALLATION 5
INSTALLATION
Installation is a quick, four-step process:
1. Assemble the scanner
2. Install the software
3. Connect and power on the scanner
4. Connect the USB cable to your computer
BEFORE YOU BEGIN
Please make sure of the following before you begin installation:
■ If your computer has AntiVirus or AntiSpyware software running,
you may see messages during installation asking you to allow the
installation to proceed. Although the messages will differ based on
the software your computer is running, in each case you should
allow the installation to proceed. Alternatively, you can turn off the
AntiVirus or AntiSpyware software before installing your scanner,
but if you do, make sure to turn it back on again when installation
is finished.
■ If you already have a scanner connected to your computer, you need
to remove its driver programs first before beginning the installation
of your Visioneer Strobe XP 470 scanner. Please see “Uninstalling
Your Scanner” on page 131 for basic instructions, or see the User’s
Guide that you received with your other scanner for specific
instructions.
■ You had the option to purchase your Visioneer Strobe XP 470
based on the software bundled with the scanner. The information
in this guide may cover software not provided with the scanner you
purchased. Please disregard any information about the software not
applicable to your chosen product.