Filter
Top Products
18 VISIONEER STROBE XP 470 SCANNER USER’S GUIDE
If you are using Windows XP, Service Pack 1, and have plugged the
USB cable into a USB 1.1 port, an information bubble may open
explaining that “A HI-SPEED USB device is plugged into a non-
HI-SPEED USB hub”. Plug the USB cable into a USB 2.0 port (if
available) or just disregard the message. If you leave it plugged into
the USB 1.1 port, your scanner may scan a bit slower than the 33
pages per minute, and 66 images per minute available with a USB
2.0 port.
Your computer then recognizes that a scanner has been plugged into
the USB port and automatically loads the appropriate software to
run the scanner.
Do not proceed until you receive a message that your computer has
found the new hardware, or updated the driver database. If your
computer is running Windows XP, you will see the following message.
Note: If you have not installed the scanner driver, unplug the USB
cable from the computer and install the software now. When the
driver installation is complete, a message tells you when to connect the
scanner.