Filter
Top Products
24
1.11
Cutting Roll Media
The lead edge of the media should be cut when the media is loaded, on
recovery from a media jam, and when the lead edge of the roll is damaged.
There are two methods for cutting the lead edge of the roll media:
• Automatic cut: This involves making selections on the printer control panel.
• Manual cut: Open the media tray and slide the cutter manually.
Refer to the section "5.7 Billing Meter Confirmation (6030/6050)" for the
6030/6050 and "5.8 Billing Meter Confirmation (6050A)" for the 6050A in
"Chapter 5 Additional Operations from the Printer Menu" for details about
automatic cutting.
Refer to section " Cutting Roll Media Manually" in this chapter.