Filter
Top Products
Xerox Nuvera Paper Guide
B-1
Printing with tabs
B. Printing with tabs
A special tabs guide is installed on the trail edge paper guide after
tab stock is loaded into the paper tray. The tabs guide prevents the
fluffers from blowing sheets with short tab extensions away from
the lead edge of the tray.
Two tabs guides are included with each feeding module. One is
labeled A4/11" and the other is A5/5.5". These tab guides are
mounted on brackets or in a molded pocket that is located inside
the Feed Module front door.
• When using the A4/11" tabs guide, tab page size is 9 x 11
inches (A4 tab size 223 x 297mm) and body page size is 8.5 x
11 inches (A4 210 x 297mm).
• When using the A5/5.5" tabs guide, tab page size is 8.5 x 6
inches (A5 tab size 161 x 210mm) and body page size is 8.5 x
5.5" (A5 148 x 210mm).
NOTE: Check with your service representative if you are not sure
that you have the required hardware for running tabs.
The A4/11" tabs guide can be installed in any tray. The A5/5.5"
tabs guide can only be installed in Trays 1 and 2.
The tabs guide should be removed from the tray once tab printing
is completed. This will reduce the chance of damaging the tabs
guide when loading normal paper.
It is recommended that tab jobs be sent to the stacker cart, not to
a stacker top tray (unless the stock size is smaller than the 7x10
inch (178x254 mm) size limitation of the stacker). When running
tab stock, the quality of the stack on the stacker cart may be
affected due to the structure of the media.
Once the tabs guide is installed, program jobs according to the
procedures for programming tab jobs
Obtaining additional tabs guide kits
If additional Feed Module Tab Guide kits (Part #600K14630) are
needed, contact your Xerox Service Representative. The
additional kits are customer installable and include installation
instructions.