Filter
Top Products
10 PA/PT400 & PA/PT 403 User’s Guide
Loading the Media
You can operate this printer in one of two different modes: Tear-Off
or Peel-Off. Tear-Off mode allows you to tear off each label (or a strip
of labels) after it is printed. In Peel-Off mode, the backing material is
peeled away from the label as it is printed. After you remove this la-
bel, the next one is printed.
Tear-Off Mode
NOTE. If ribbon is loaded (PT models only), remove the
ribbon cartridge before loading the media.
1. Refer to Figure 4. Raise the media access door by lifting at the
notch until it unhooks from the top cover.
Top Cover
Notc
h
Media
Access
Door
F
IG
. 4
2. Refer to Figure 5. Swing the media access door open to ex-
pose the media compartment.
3. Pivot the top cover to reveal the printhead.
4. Lift the printhead until you feel it “lock” into place. Be careful not
to force the printhead past this position!
WARNING: NEVER touch the thermal print elements on
the underside of the printhead. Under certain conditions,
they can be very hot! Also, dirt or moisture from your
hands can damage the printhead!