Filter
Top Products
14 PA/PT400 & PA/PT 403 User’s Guide
NOTE.- When not in use, the tear bar may be stored on the
inside of the media access door. Refer to Figure 9. With the
lip of the bar facing the inside of the door, simply align the
notches of the bar with the tabs on the door. Press and slide
the bar toward the door’s hinged end.
If you’re using direct thermal media, continue on with step 10.
However, if you’re using a PT series printer with thermal transfer
media, you must also install a ribbon cartridge. Proceed to
“Loading the Ribbon ‘ in this chapter.
10. Close the
printhead and
the top cover.
11. Swing up the
media access
door, ensuring
that the media
liner is thread-
ed through the
wide slot in the
media access
door (refer to
Figure 10).
12. Lift to hook
the top of the
media access
door over the
top cover.
Tear Bar
Notch
Tear Bar
Notch
Door
Tab
Door
Tab
Label
Wide Slot
Backin
g
Materia
l
F
IGURE
9
F
IGURE
10