Filter
Top Products
12 PA/PT400 & PA/PT 403 User’s Guide
9. Refer to Figure 7. If it’s not already in place, install the tear bar
in the media access door. Gently lift the tab on the bar to move
it over the protrusion on the door. Make sure the lip of the bar
(inset, Figure 7) faces out of the printer.
If you’re using direct thermal media, continue on with step 10.
However, if you’re using thermal transfer media, you must also
install a ribbon cartridge. Proceed to “Loading the Ribbon “ in
this chapter.
Tab
Lip
Protrusion
10. Close the printhead and the top cover.
11. Swing up the media access door, ensuring that the media ex-
tends over the tear bar (refer to Figure 8).
12. Lift to hook
the top of the
media access
door over the
top cover.
13. Push in the
bottom of the
media access
door to close.
14. Turn on the
printer or press
the Feed button
if the printer is
already on.
Tear Ba
r
F
IGURE
7
F
IGURE
8