Filter
Top Products
PA/PT400 & PA/PT 403 User’s Guide 39
Label Specifications
Label/Tag Width 1" to 4.25" (25.4 mm to 108 mm)
Fanfold Width 3.5" to 4.25" (89 mm to 108 mm)
Label/Tag Length 0.5" to 10" (1 2.7 mm to 254 mm) 400 Series;
0.5” to 70” (1 2.7 mm to 1778 mm) 403 Series
Inter-label Gap. 08" to .16" (.12" preferred)
2 mm to 4 mm (3 mm preferred)
Label/Tag Thickness .0030- to .0106- (.076 mm to .269 mm)
Label RollSize:
Max.Diameter 2.1" (53.3 mm)
Inner Core 1" (25.4 mm)
Use Zebra-brand direct thermal or thermal transfer roll
media that is outside wound. Media may be reflective
(black mark) sensing or transmissive sensing, die-cut,
notched, or continuous.
For die-cut labels, use only full auto dies.
Media Requirements Notched media must have a 0.5" (1 2.7 mm) wide x
0.094” (2.4 mm) long cutout located in the center of the
roll. The reflective media black marks must be located in
the center of the roll.
Minimum Black Mark Dimensions:
Mark width: 0.5” (12.7mm) perpendicular to the edge of
the media.
Mark length: 0.094” (2.4 mm) parallel to the edge of the
media.
Memory/Communications Specifications
ROM Memory 1 MB flash (400 Series); 2MB flash (403 Series)
RAM Memory 512 KB DRAM (400 Series); 2 MB DRAM (403 Series)
Communications RS-232 serial port (RJ45 connector)
Configurable Baud rate (from 110 to 19,200 Baud),
parity and data bits.
Software (X-ON/X-OFF) or hardware (DTR/STR)
communication handshake protocols.
Error detection CRC protocol
Optional infrared wireless link (meets IrDA 1.1
specifications) 2,400 to 115,200 Baud rate