Filter
Top Products
Introduction
ZT230 Printer Control Panel Display
22
P1048261-004 8/22/12
SETTINGS Menu (continued)
Items in this menu are shown in the order in which they appear when you press the RIGHT
ARROW. For more information about these settings, see Table 7, Print Settings on page 79.
Set the Reprint Mode
When reprint mode is enabled, you can reprint the last label printed
either by issuing certain commands or by pressing the LEFT
ARROW on the control panel.
See Reprint Mode on page 82 for more information.
Set the Maximum Label Length
Set the maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length plus the interlabel
gap. If you set the value to one that is smaller than the label length,
the printer assumes that continuous media is loaded, and the printer
cannot calibrate.
See Maximum Label Length on page 82 for more information.
Select the Display Language
If necessary, change the language that the printer displays. See
Language on page 92 for more information.
Note • The selections for this parameter are displayed in
the actual languages to make it easier for you to find one
that you are able to read.
▼
REPRINT MODE
OFF
▲
▼
LABEL LENGTH MAX
39
▲
▼
LANGUAGE
ENGLISH
▲