Filter
Top Products
95
Printer Configuration and Adjustment
Changing Printer Settings
8/22/12 P1048261-004
Sensor Settings
Table 11 • Sensor Settings
Sensor Type Select the Media Sensor
Select the media sensor that is appropriate for the media that you are using. The
reflective sensor can be used with all media types. The transmissive sensor should be
used only for simple gap media.
Accepted values:
• TRANSMISSIVE
• REFLECTIVE
Related ZPL command(s):
^JS
SGD command used:
device.sensor_select
Control panel menu item: SENSOR TYPE on page 34
Printer web page:
View and Modify Printer Settings > Media Setup
Label Sensor Set the Sensitivity of the Label Sensor
Important • This value is set during sensor calibration. Do not change this
setting unless you are told to do so by Zebra Technical Support or by an
authorized service technician.
Accepted values:
0 – 255
Related ZPL command(s):
none
SGD command used:
ezpl.label_sensor
Control panel menu item: LABEL SENSOR on page 34
Printer web page:
View and Modify Printer Settings > Calibration
Take Label Set the Intensity of the Take Label LED
Important • This value is set during sensor calibration. Do not change this
setting unless you are told to do so by Zebra Technical Support or by an
authorized service technician.
Accepted values:
0 – 255
Related ZPL command(s):
none
SGD command used:
ezpl.take_label
Control panel menu item: TAKE LABEL on page 35
Printer web page:
View and Modify Printer Settings > Calibration