Filter
Top Products
Chapter 1: Installation Instructions 13
Step 3: Establishing
Communication
Important!
Macintosh and Linux users must make sure that the computer’s
TCP/IP settings are configured properly BEFORE starting this
section. See Macintosh TCP/IP Settings on page 51 or Linux
TCP/IP Settings on page 53 for instructions.
You must set up the X5 so that it can communicate with your
Internet service provider. To do this, you must use the Zoom
Configuration Manager.
1
11
1
Log in to the Zoom Configuration Manager from the
computer you connected to the X5 modem:
a
aa
a
Open your Web browser and, in its address bar, type
http://10.0.0.2 if you are using the Ethernet jack or
http://10.0.0.3 if you are using the USB port (Windows
only), then press the Enter key on your keyboard.
Tip!
If you are using a Windows computer, a Zoom icon
should have been placed on your desktop automatically.
Instead of typing one of the addresses above in your Web
browser, you can double-click the Zoom icon.
b
bb
b
When prompted, type the following user name and
password in the appropriate boxes, then click OK. You
must enter them using lowercase letters.
User Name:
admin
Password:
zoomadsl
If you are not prompted for a user name and password, do
the following in this order: Recheck all connections; restart
the modem and computer; and reset the modem by
inserting a paper clip into the Reset pinhole in the center
of the modem’s back panel and holding it for five seconds.
The user name and password you enter here do not serve
the same purpose as any name and password that your
Internet service provider may have given you.