Filter
Top Products
Chapter 1: Installation Instructions 19
Configuring the X5 Manually
Some users may need to configure the X5’s IP settings manually,
instead of having the modem automatically configure itself.
Typically, you would manually configure your modem if:
• You already have the VPI, VCI, and Encapsulation settings
from your Internet service provider.
• You have a static IP address that you plan to use with the X5.
If this is the case, skip this section and continue with Using
Static IP Addressing on page 22.
• The auto configuration process was unable to find your
settings.
Manually configuring the modem requires that you log in to the
Zoom Configuration Manager and enter information on its
Basic Setup page. (If you need help logging in, see page 13.)
1
11
1
On the Basic Setup page, ensure that the MANUAL option
button is selected.
2
22
2
Do the following, depending on whether you know your VPI,
VCI, and Encapsulation settings:
!
If your Internet service provider gave you the settings,
continue with step 3 below.
!
If you do not know the settings, refer to the ADSL
Internet Settings Tables beginning on page 45. Find
your service provider on the list and make note of its
settings. If there is more than one listing for your service
provider, the most common one is labeled (1), the next (2),
and so on.
Tip:
If you are in the United States and your service provider is
not on the list, use the settings for Service Provider Not
Shown at the bottom of the table.