Filter
Top Products
Chapter 1: Installation Instructions 19
Hook Flash -
If you receive a second call while you are on a VoIP
call, you will hear a call waiting tone. Momentarily press the hook
button on your phone to talk to the second caller, and press it
again to go back to your first conversation. After you have
completed a VoIP call, you can press the hook button to get a
fresh VoIP dial tone and make another VoIP call without dialing
#
(Note that redial or speed dialing will not work in this case,
however. You must hang up for at least one second if you need to
make a conventional phone call.
1.4 Setting the V3 for VoIP Only
Mode
For models outside of the US, the V3 can be set to operate in
VoIP Only Mode
. While in
VoIP Only Mode
, you do not need
to dial # before dialing a number. Use
VoIP Only Mode
when:
•
You have a cable modem and you are not near a phone jack
that you can plug the V3 into.
•
You are using a DSL modem and your DSL line also provides
your ISDN service.
•
You are using “unbundled” DSL—that is, a line without any
telephone service attached to it.
•
You intend to use the phone connected to the V3
solely
for
VoIP calls. That way, you do not have to hit
#
before every
call.
To put the V3 in
VoIP Only Mode
, follow these steps:
1
11
1 From the
Zoom Configuration Manager
, click the
Voice
Over IP
icon at the top of the page.
2
22
2 Check the
VoIP Only Mode
box.
3
33
3 Click
Save Changes
,
Write Settings to Flash and Reboot
,
and
Confirm
.