Filter
Top Products
Prestige 1600 Universal Access Concentrator
16-4
IP Policy Routing
Table 16-2 IP Routing Policy
Field Description
Policy Set Name
This is the name of the policy set assigned in Menu 25 - IP Routing Policy
Setup.
Active
Press the spacebar to select Yes to activate the policy.
Criteria
IP Protocol IP layer 4 protocol, e.g., UDP, TCP, ICMP, etc.
Type of Service
Prioritize incoming network traffic by choosing from Don’t Care/
Normal / Min Delay / Max Thruput / Max Reliability.
Packet Length Enter the length of incoming packets (in bytes). The operators in the
Len Comp (next) apply to packets of this length.
Len Comp
Press the spacebar to choose from Equal / Not Equal / Less /
Greater / Less or Equal / Greater or Equal.
Precedence Precedence value of the incoming packet. Values range from 0 to 7
or Don’t Care.
Source:
addr start= / end= Source IP address range from start to end.
port start= / end= Source port number range from start to end; applicable only for
TCP/UDP.
Destination:
addr start= / end= Destination IP address range from start to end.
port start= / end= Destination port number range from start to end; applicable only for
TCP/UDP.
Action=
Specifies whether action should be taken on criteria Matched or Not
Matched.
Gateway addr Defines the outgoing gateway address. The gateway must be on the
same subnet as the Prestige if it’s on the LAN, otherwise, the
gateway must be the IP address of a remote node. The default
gateway is specified as 0.0.0.0.
Log
Press the spacebar to select Yes to make an entry in the system log
when a policy is executed.
Type of Service Set the new TOS value of the outgoing packet. Choose from Prioritize
incoming network traffic by choosing from No Change / Normal / Min
Delay / Max Thruput / Max Reliability.
Precedence Set the new precedence value of the outgoing packet. Values range
from 0 to 7 or No Change.
16.3 Applying an IP Policy
This section shows you where to apply the IP Policies after you design them.
16.3.1 Ethernet IP Policies
From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -TCP/IP Ethernet Setup.