Filter
Top Products
Prestige 1600 Universal Access Concentrator
6-4
DSL Port Setup
Field Description Option
Authen(ticatio
n) Method
This field sets the authentication method for
incoming calls. You can choose Local or RADIUS.
The default for this field is Local. Please see the
next section on User Authentication for more details.
Local, RADIUS
Protocol Press the [SPACE BAR], then [ENTER] to choose
from None, CHAP/PAP, CHAP or PAP. The default
is None.
None, CHAP, PAP, CHAP/PAP
User Name This will be used as the login name for local
authentication. You can enter a name with up to 31
characters. This will be N/A when you choose
RADIUS as your authentication method.
Password Enter the password for the remote user. This will be
N/A when you choose RADIUS as your
authentication method.
IP Address
Assigned to
Client
Refers to the IP address assigned to the CPE
(Customer Premises Equipment), i.e., the client
device connected to the Prestige.
Start of Public
IP Address
Refers to the public IP address assigned to the
hosts behind the CPE. The IP range contains
contiguous IP addresses and this field specifies the
first one in the range.
IP Count In this field enter the number of addresses in the
public IP range. For example, if the starting address
is 202.x.x.1 and the IP count is 6, then the pool will
be from 202.x.x.1 to 202.x.x.6.
Multicast Turn on/off IGMP support IGMP-v2/IGMP-v1/None.
Please refer to the Multicast section earlier in this
manual for more details about this feature.
IGMP-v1
IGMP-v2
None
IP Policies You can apply up to four IP policy sets (from twelve)
by entering their numbers separated by commas,
e.g., 3, 4, 6, and 11.
6.1.1 Example IDSL Port Setup
In Menu 6.1, the Start of Public IP Address and IP Count fields are for public IP addresses only. If NAT is not
enabled, and the hosts behind the CPE have been assigned public IPs, then you must enter that information here to
enable proper routing.