Filter
Top Products
Chapter 5 Broadband
ADSL Series User’s Guide
89
The following table describes the fields in this screen.
5.2.1 Add/Edit Internet Connection
Use this screen to configure a WAN connection. The screen varies depending on the encapsulation
method used and WAN service type you select.
5.2.1.1 Routing- PPPoE
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Routing as the encapsulation mode and
PPPoE as the WAN service type.
Table 10 Network Setting > Broadband
LABEL DESCRIPTION
Add new WAN
Interface
Click this to create a new WAN interface.
Internet Setup
# This is the index number of the connection.
Name This is the service name of the connection.
Type This shows the type of interface used by this connection.
Mode This shows whether the connection is in routing mode or bridge mode.
Encapsulation This shows the method of encapsulation used by this connection.
VPI This is the Virtual Path Identifier (VPI).
VCI This is the Virtual Channel Identifier (VCI).
Vlan8021p This indicates the 802.1P priority level assigned to traffic sent through this connection.
This displays N/A when there is no priority level assigned.
VlanMuxId This indicates the VLAN ID number assigned to traffic sent through this connection.
This displays N/A when there is no VLAN ID number assigned.
ATM QoS This shows the ATM Quality of Service (QoS) type configured for this connection. This
displays N/A when there is no ATM QoS assigned.
IGMP Proxy This shows whether IGMP (Internet Group Multicast Protocol) is activated or not for
this connection.
NAT This shows whether NAT is activated or not for this connection. NAT is not available
when the connection uses the bridging service.
Default Gateway This shows whether the ZyXEL Device uses the interface of this connection as the
system default gateway.
Modify Click the Edit icon to configure the connection.
Click the Delete icon to delete this connection from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the connection.