Filter
Top Products
Chapter 5 Broadband
ADSL Series User’s Guide
99
Figure 26 Broadband Add/Edit: Bridge (ADSL)
The following table describes the fields in this screen.
Table 14 Broadband Add/Edit: Bridge (ADSL)
Label
DESCRIPTION
General
Name Enter a service name of the connection.
Type Select ADSL as the interface for which you want to configure here.
The ZyXEL Device uses the ADSL technology for data transmission over the DSL port.
Mode Select Bridge when your ISP provides you more than one IP address and you want
the connected computers to get individual IP address from ISP’s DHCP server directly.
If you select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP
server and NAT on traffic from the selected LAN port(s).
Bridge Group Select the LAN/WLAN port(s) from which traffic will be forwarded to the WAN interface
directly.
Select a port from the Available LAN/WLAN Port(s) list and click Add >> to add it
to the Bridged LAN/WLAN Port(s) list.
If you want to remove a port from the Bridged LAN/WLAN Port(s) list, select it and
click Remove <<.
You cannot configure a QoS class for traffic from the LAN port which is selected here.
ATM PVC
Configuration
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
This section is available only when you select ADSL in the Type field to configure an
ATM layer-2 interface.
VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management
of ATM traffic). Enter the VCI assigned to you.